These dry contact relays energize the location of P39 on the RSA III.The alarm horn sounds giving a minimum all generator set models except 450500REOZVB and 70 dB at 0.1 m (0.3 ft.) audible alarm when a warning or 80--150REOZJD.The ATS TEST model, up to 41 LED indicators on the single ATS model, pushbutton will only operate when the control keyswitch and up to 65 LED indicators on the multiple ATS model is in the unlock position and the ATS is not in local-test.
Decision Maker 3000 Controller Software To OptionalUse the SiteTecht software to optional engine block heater malfunctions andor select the EPS source from the following choices: engine coolant temperature is too low.
Any digital input from the Kohler generator controllers and ATS can be associated with any of the five user input LEDs. On the controller base box and automatic voltage regulator, do not touch the terminals for voltage and current measurement. Read the entire installation procedure and compare kit parts with parts list in this publication before beginning If the unit is an 80--150REOZJD or 450500REOZVB installation. Decision Maker 3000 Controller Serial Annunciator 4P21 RS-485 communication connection for remote serial annunciator 4. Note: Requires DEC 3 controller logic (red) circuit board GM28725. Note: Perform step 3 with GM91356-S4, -S5, or -S6 and GM32644-KP1 kit. Remove the existing three nuts attaching the indicator panel circuit board. If user-selected inputs 1--2 (remote) Not used are used, the user may add the identification on Not used the RSA III front panel strip. This procedure is ATS Position Input Return further explained in step 6.13 of this instruction. GM85125-A Figure 17 RSA III Mounting Hole Dimensions in Supplied Box GM85123 Remove four screws X-67-154 from the RSA III 5.3.3 Drill an appropriate size hole in box bezel GM85134 and remove bezel from the GM85125 if a user-supplied conduit RSA III box GM85123. To determine Throughout step 6, refer to the following illustrations. ![]() Figure 22. APM802 DEC 8000 controllers have a terminating resistor located on the controller. Note: When using RS-485 communication cable, connect the shield wire at the RSA III P27 connection but not at the APM802 controllerTB10 connection. Figure 31 shows the DEC 3000 controller with P21 location and DEC 3500 controller with TB12 location and Figure 30 shows the RS-485 connections. Figure 33 shows the RS-485 connections and Figure 35 shows the DEC 6000 controller with P20 location. The APM802 and DEC 8000 controllers have a terminating resistor located on the controller. Each RSA III P37 Power Connections requires a 1224-volt, 200 mA (min.) DC power P37-1 Ground source. The RSA III voltage should match the P37-2 1224 VDC battery input1 (not polarity sensitive) generator set starting system. Provide an engine P37-3 1224 VDC battery input2 (not polarity sensitive) starting battery connection to P37. See P40, 6-pin common fault output and horn dry Figure 39 for P39 connections.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |